Lotus Equipment Sales Ltd.
120, 5726 Burleigh Cr. S.E.
Calgary, Alberta, Canada
T2H 1Z8
Phone: (403)253-0822 1-800-661-0002
Fax: (403)253-8684 1-800-661-0007
Email: donnas@lotus-equip.com
Lotus Equipment Sales Ltd.
120, 5726 Burleigh Cr. S.E.
Calgary, Alberta, Canada
T2H 1Z8
Phone: (403)253-0822 1-800-661-0002
Fax: (403)253-8684 1-800-661-0007
Email:
donnas@lotus-equip.com
Sendec 806-100, 806-101, 806-102 Installation Instructions
Installation: Easy As 1-2-3
1> Find a convenient mounting location, be sure the pick up wire will reach the spark plug wire. If not, substitute with a wire of the same outside diameter of no less than 22 gauge, up to 8 feet long. DO NOT mount meter where surface temperature exceeds 1251 F.. As a general guideline, if you can place your hand on the mounting surface without discomfort while equipment is at full operating temperature, then it will be suitable to mount meter in that location.
2>Use drill template (Fig.1) to locate mounting holes. DO NOT DRILL INTO GAS TANKS OR ENGINE CRANKCASE.
3>Secure pick-up wire into meter by placing wire over channel and pushing down with a flat screwdriver. Wire must be seated completely in channel (see Fig. 2). Fasten meter to mounting surface with supplied screws. Route wire to spark plug wire and attach as shown in Figure 3.
